An information about the mains devider This device devides the main supply voltage, that in Sweden is AC 230 V, into a voltage between 0 volts and 260 volts. The mains devider consists of a coil with a closed magnetic core. After the devider there is a trans- former, which in unloaded state leaves 130 V and 260 V to the outputs. The switches 115 volts and 230 volts (marked I and II) A change-over from 115 V to 230 V. At first switch II. Next switch I. A change-over from 230 V to 115 V. At first switch I. Next switch II. If you're switching in another way, there will be a short-circuit. But in that case there is a fuse of 0.8 A. If the outputs of device are very loaded, you should remove the lid. Technical specifications The total maximum output power: 50 VA (always concerns 115 V output and 230 V output) At relatively low output voltages: Terminal 0 - 115 V: maximum 1.6 amps Terminal 0 - 230 V: maximum 0.8 amps The lowest internal resistance: 25 ohms (115 volts) The highest internal resistance: 110 ohms (230 volts)   Göran Holbeck Klippan August, 2000 SWEDEN Back